SI-DRIVE 297 |
|||
|
OIL TEMP” warning light will illuminate. Immediately stop the vehicle in a safe place and let the engine idle until the warning light turns off.
For models with SI-DRIVE, by selecting the Sport Sharp( S #) mode, upshifting will not occur automatically. According to the road conditions, perform the shift change manually so that the tachometer needle does not enter the red zone. Also, if the engine revolutions reach the specified number, the fuel supply will be cut. In this case, perform shift up operation.
For models with Drive Mode Select, by selecting the Sport + mode, upshifting will not occur automatically. According to the road conditions, perform the shift change manually so that the tachometer needle does not enter the red zone. Also, if the engine revolutions reach the specified number, the fuel supply will be cut. In this case, perform shift up operation.
& Driving Tips s07bg05
NOTE
If the accelerator and brake pedals are depressed at the same time, driving torque may be restrained. This is not a
|
malfunction.
. On a road surface where there is a risk of wheelspin( for example, a snow- or gravel-covered road), you can pull away from a standstill safely and easily by first selecting the 2nd gear of the manual mode.
. Always apply the foot or parking brake when the vehicle is stopped in the“ D” or“ R” position.
. Make sure to apply the parking brake when parking your vehicle. Do not hold the vehicle with only the transmission.
. Do not keep the vehicle in a stationary position on an uphill grade by using the“ D” position. Use the brake instead.
. The engine may, on rare occasions, knock when the vehicle rapidly accelerates or rapidly pulls away from a standstill. This phenomenon does not indicate a malfunction.
|
7-8. SI-DRIVE( If Equipped)
s07bc
SI-DRIVE( SUBARU Intelligent Drive) works to maximize engine performance, control and efficiency.
This system consists of three modes:. Intelligent( I) mode. Sport( S) mode. Sport Sharp( S #) mode
Sport( S) mode is selected when the pushbutton ignition switch is turned to the“ ON” position. By adjusting the SI-DRIVE switches, the character of the power unit changes.
|
7
Starting and Operating
|
– CONTINUED – |