|
down.
& Entering the Vehicle Following Remote Engine Start Shutdown s07az10
An alarm trigger may occur if the vehicle is opened by the access key fob within a few seconds immediately following remote engine start shutdown.
& Heating or Cooling the Interior of the Vehicle s07az04
After the system starts the engine, the heater or air conditioning will activate and heat or cool the interior to a factory default temperature setting, with automatic selected for all other settings.
& Remote Transmitter Program( Remote Engine Starter Transceiver) s07az13
New transmitters can be programmed to the remote engine start system in the event that a transmitter is lost, stolen, damaged or additional transmitters are desired( the system will accept up to eight transmitters). New remote engine start transmitters can be programmed according to the following procedure.
|
1. Open the driver’ s door( the driver’ s door must remain open throughout the entire process).
2. Depress and hold the brake pedal.
3. Turn the ignition switch to“ ON” then“ OFF”, back to“ ON” then“ OFF”, back to“ ON” then“ OFF”, then back to“ ON” again and leave the ignition“ ON” throughout the programming process.
4. The system will flash the side marker lights, tail lights and parking lights and honk the horn three times, indicating that the system has entered the transmitter learn mode.
5. Press and release the“” button on the transmitter that you want to program.
6. The system will flash the side marker lights, tail lights and parking lights and honk the horn one time, indicating that the system has learned the transmitter. Upon successful programming, the remote start confirmation transmitter button will flash one time.
7. Repeat step 5 for any additional transmitters( the system will accept up to eight transmitters).
8. The system will exit the transmitter learn mode if the ignition switch is turned to the“ OFF” position, the door is closed or after 2 minutes.
|
& System Maintenance s07az09
NOTE
For remote engine starter transceiver:
In the event that the vehicle’ s battery is replaced, discharged or disconnected, it will be necessary to start the vehicle a minimum of one time using the key prior to activating the remote engine start system. This is required to allow the vehicle electronic systems to resynchronize.
! Changing the battery
|
CAUTION
s07az0901
. Do not let dust, oil or water get on or in the remote engine start transmitter when replacing the battery.
. Be careful not to damage the printed circuit board in the remote engine start transmitter when replacing the battery.
. Be careful not to allow children to touch the battery and any removed parts; children could swallow them.
. There is a danger of explosion if an incorrect replacement battery is used. Replace only with the
|
7
Starting and Operating
|
||
– CONTINUED – |