130
Alarm System
& Disarming the System s02af05
Perform either of the following procedures.
. Briefly press a button( for less than 2 seconds) on the access key fob.
. Carry the access key fob and perform either of the following procedures. – Grip the front door handle. – Press the trunk opener button. – Unlock using the PIN code access.
The flashing of the security indicator light will then change slowly( once approximately every 3 seconds from twice approximately every 2 seconds), indicating that the alarm system has been disarmed.
! Emergency disarming s02af0501
If you cannot disarm the system using the access key fob( i. e., the access key fob broken or the access key fob battery is too weak), refer to“ Switching Power Status” FP401.
NOTE
If the access key fob battery is too weak, replace the battery immediately. Refer to“ Replacing Battery of Access Key Fob” FP457.
& Alarm System Setting s02af11
To change the setting of your vehicle’ s alarm system for activation or deactivation, do the following.
1. Disarm the alarm system. Refer to“ Disarming the System” FP130.
2. Sit in the driver’ s seat and shut all doors, the trunk lid and engine hood.
3. Turn the ignition switch to the“ ON” position.
4. Hold down“” of the driver’ s power door locking switch, open the driver’ s door within the following 1 second, and wait 10 seconds without releasing the switch. The setting will then be changed as follows.
Setting status
Combination meter
Horn
Activate |
AL ON |
Once |
Deactivate |
AL OFF |
Twice |
NOTE
You may have the above setting change done by your SUBARU dealer.
& If You Have Accidentally Triggered the Alarm System
s02af03
! To stop the alarm s02af0301
Do any of the following operations:. Press any button on the access key fob.
. Turn the push-button ignition to the“ ACC” position.
NOTE
Only registered keys will stop the alarm. If the immobilizer transponder is not registered, the alarm will not stop.