|
may be reduced, or the keyless access function may not operate. In such a case, perform the procedure described in“ Locking and Unlocking” FP401.
. The doors may lock or unlock when the car is being washed or exposed to a significant amount of water that touches the door handle while the key fob is still in the operating range.
! How to lock and unlock s02ap0108
It is possible to perform the following operations when you are carrying the access key fob.
. Lock and unlock the doors and the fuel filler lid.
. Unlock the trunk lid.
NOTE
. It is not possible to lock the doors and fuel filler lid using the keyless access function when the pushbutton ignition switch is in the“ ACC” or“ ON” position. Refer to“ Switching Power Status” FP144.
. If the door handle is gripped with a gloved hand, the door lock may not be released.
. If the door lock sensor is touched three times or more repeatedly, the system will ignore the sensor operation
|
.
. When performing the locking procedure too quickly, locking may not complete. After performing the locking procedure, it is recommended to pull the rear door handle to confirm that the doors have been locked.. If any of the doors are not fully closed, the following will occur to alert you that the doors are not properly closed. – An electronic chirp sounds five times. – The hazard warning flashers flash five times.
. It is possible to lock the doors even when one of the doors is open. After performing the locking procedure, close the opened door to lock it.
. Within 3 seconds after locking the doors using the keyless access function, it is not possible to unlock doors using the keyless access function.
. When locking, be sure to carry the access key fob to prevent locking the access key fob in the vehicle.
. The setting of the hazard warning flasher operation can be changed by operating the center information display. For details, refer to“ Car settings” FP200. Also, the setting of
|
the hazard warning flasher operation can be changed by your SUBARU dealer. Contact your SUBARU dealer for details.
! Locking with the door lock sensor s02ap010801
1 Door lock sensor
Carry the access key fob, close all the doors and touch the door lock sensor on the door handle. All the doors( including the fuel filler lid) will be locked. Also, an electronic chirp will sound once and the hazard warning flashers will flash once.
NOTE
After touching the door lock sensor to lock all of the doors, if you touch the door lock sensor once more to attempt the lock operation without first unlock-
|
2
Keys and Doors
|
||
– CONTINUED – |