392
Flat Tires
4 . Connect the power plug of the air compressor into the accessory power outlet .
Apply the parking brake and turn on the ignition switch to the “ ACC ” position . Turn the air compressor switch on and adjust the air pressure to the appropriate level ( green zone of the air gauge ).
CAUTION
. Do not run the air compressor for more than 10 minutes as it can get hot . Be careful not to get burned .
. If tire pressure doesn ’ t reach the green zone for 10 minutes , this kit will be unable to seal the tire . Please contact your SUBARU dealer for help .
NOTE
. After the compressor starts to operate , the air pressure will temporarily rise to 45 psi ( 300 kPa , 3.0 kgf / cm 2 ) or higher . After about 30 seconds when all of the sealant is inside the tire , the air pressure will lower , representing the air pressure in the tire .
. In extremely low temperatures −228F to −48F ( −308C to −208C ), the viscosity of the sealant increases and the sealant will flow more slowly . In such temperatures , bring the sealant into the vehicle to warm it up before use .
. When mending the tire , if the air pressure gauge is hard to read , turn the compressor switch off once to get an accurate reading .