298
Starting and Stopping Engine ( Models with Push-Button Start System )
CAUTION
For CVT models :
. Do not stop the engine while the select lever is in a position other than the “ P ” position .
. If the engine is stopped while the select lever is in a position other than the “ P ” position , the power will be in “ ACC ”. If the vehicle is left in this condition , the battery may be discharged .
! When the steering lock cannot be released s07be0701
! Operation indicator flashing in orange s07be070102
There may be a malfunction in the steering lock function . Immediately contact your nearest SUBARU dealer .
NOTE
Although you can stop the engine by operating the push-button ignition switch , do not stop the engine during driving except in an emergency .
& When Access Key Fob Does Not Operate Properly s07be05
Refer to “ Access Key Fob – If Access Key Fob Does Not Operate Properly ” FP405 .
& Steering Lock s07be07
After stopping the engine and any door is opened , the steering wheel will be locked due to the steering lock function .
When the engine is restarted , the steering lock will be automatically released .
1 Operation indicator 2 Push-button ignition switch
When you cannot restart the engine due to the steering lock , check the status of operation indicator and perform the following steps .
! Operation indicator flashing in green s07be070101
1 . Check that the select lever is set in the “ P ” position ( CVT models ).
2 . Depress the brake pedal and keep it .
3 . Press the push-button ignition switch while turning the steering wheel left and right .