224
Light Control Switch
twice . When performing the unlocking procedure after performing the locking procedure , perform the locking procedure twice again .
* 1 : The setting for the period of time in which the low beam headlights remain on by the welcome lighting function can be changed by a SUBARU dealer . Contact your SUBARU dealer for details . Also , you can change the setting by operating the center information display . For details , refer to “ Car settings ” FP198 ( 11.6-inch display models ) or “ Car Settings icon ” FP211 ( dual 7.0-inch display models ).
! Battery drainage reduction function s03ah0107
When the headlights are illuminated under the following conditions , the battery drainage reduction function will be active .
. The push-button ignition switch is turned to the “ OFF ” status ( models with “ keyless access with push-button start system ”).
. The key is pulled out from the ignition switch ( models without “ keyless access with push-button start system ”).
When the battery drainage reduction function is active , the following system operations help reduce the risk of battery discharge .
. The headlights turn off automatically after 10 minutes .
. When you open or close the door or operate the headlight control switch , the headlights will turn off automatically 10 minutes later .
NOTE
. When you leave the vehicle , put the light control switch in the “ OFF ” position to prevent battery discharge .
. When you open or close the door or operate the headlight control switch after the headlights turn off automatically , the headlights will turn on again .
! Sensor for the auto on / off headlights s03ah0101
The sensor is on the dashboard as shown in the illustration .
CAUTION
If any object is placed on or near the sensor , the sensor may not detect the level of the ambient light correctly and the auto on / off headlights may not operate properly .
& High / Low Beam Change ( Dimmer )
s03ah02
While the light control switch is in the “ ” or “ AUTO ” position in a dark place , the headlights will turn on .
Pushing the lever forward and releasing it will activate the high beam . Pulling the