Alarm System 131 |
||||||||||||
|
remote transmitter .
The system can be disarmed if you turn the ignition switch from the “ LOCK ”/“ OFF ” position to the “ ON ” position with a registered key / access key fob .
NOTE
For models with “ keyless access with push-button start system ”, if the access key fob battery is discharged , perform the procedure described in “ Switching Power Status ” FP405 . In such a case , replace the battery immediately . Refer to “ Replacing Battery of Access Key Fob ” FP461 .
|
& Alarm System Setting s02af11
To change the setting of your vehicle ’ s alarm system for activation or deactivation , do the following .
1 . Disarm the alarm system . Refer to “ Disarming the System ” FP130 .
2 . Sit in the driver ’ s seat and shut all doors , the trunk lid and engine hood .
3 . Turn the ignition switch to the “ ON ” position .
4 . Hold down “ ” of the driver ’ s power door locking switch , open the driver ’ s door within the following 1 second , and wait 10 seconds without releasing the switch . The setting will then be changed
|
as follows .
Setting status
Combination meter display ( color LCD )
Horn
NOTE
You may have the above setting change done by your SUBARU dealer .
& If You Have Accidentally Triggered the Alarm System
s02af03
! To stop the alarm s02af0301
Do any of the following operations :
. Press any button on the access key fob / remote transmitter .
. Turn the ignition switch to the “ ON ” position ( models without “ keyless access with push-button start system ”).
. Turn the push-button ignition to the “ ACC ” position ( models with “ keyless access with push-button start system ”).
NOTE
Only registered keys will stop the alarm . If the immobilizer transponder is not registered , the alarm will not stop .
|
& Valet Mode s02af06
When you choose the valet mode , the alarm system does not operate . In valet mode , the remote transmitter is used only for locking and unlocking the doors and panic activation .
To enter the valet mode , change the setting of your vehicle ’ s alarm system to deactivation mode . Refer to “ Alarm System Setting ” FP131 . The security indicator light will continue to flash once every 3 seconds , indicating that the system is in the valet mode .
To exit valet mode , change the setting of your vehicle ’ s alarm system to activation mode . Refer to “ Alarm System Setting ” FP131 .
|
2
Keys and Doors
|