474 6-4 . Using the other interior features
1 Within 5 seconds after programming the garage door opener has been completed , if the garage door opener motor is trained to Home-
Link ® , both garage door operation indicators will flash rapidly ( green ) and the light on the garage door opener motor will blink twice , indicating that 2-way communication is enabled .
If the indicators do not flash , perform 2 and 3 within the first 10
presses of the HomeLink ® button after programming has been completed .
2 Press a programmed Home-
Link ® button to operate a garage door .
3 Within 1 minute of pressing
the HomeLink ® button , after the garage door operation has stopped , press the “ Learn ” or “ Smart ” button on the garage door opener motor . Within 5 seconds of the establishment of 2-way communication with the garage door opener , both garage door operation indicators in the vehicle will flash rapidly ( green ) and the light on the garage door opener motor will blink twice , indicating that 2-way communication is enabled .
■ Reprogramming a single HomeLink ® button
When the following procedure is performed , buttons which already have devices registered to them can be overwritten : 1 Press and hold the desired
HomeLink ® button .
2 When the HomeLink ® indicator starts flashing orange ,
release the HomeLink ® button and perform “ Programming HomeLink ® ” 1 ( it takes 20 seconds for the Home-
Link ® indicator to start flashing ).
■ Before programming
●Install a new battery in the transmitter .
●The battery side of the transmitter must be pointed away from the
HomeLink ® buttons .
Operating HomeLink ®
Press the appropriate Home-
Link ® button . The HomeLink ® indicator light should turn on .
The status of the opening and closing of a garage door is shown by the garage door operation indicators .