128 2-2 . Charging
■ Meter display while charging
After turning the power switch to ON while charging , the power switch automatically turns off if My Room Mode is not selected within approximately 100 seconds .
■ When using My Room Mode the following may occur
●When the remaining charge of the traction battery drops to the lower limit , the air conditioning system
automatically stops . In that case , the air conditioning system can not operate until the remaining
charge of the traction battery increases . Turn off the power switch once , then use My Room
Mode after the remaining charge of the traction battery increases .
●The charging time of the traction battery gets longer .
●Noise may be heard from the radio depending on conditions of the radio wave .
●The surrounding area of the onboard traction battery charger
in the motor compartment may become hot .
● The electric power steering system warning light ( yellow ) may turn on , but this is not a malfunction .
●When charging the battery in normal mode , the amount of charge is controlled so that the battery is not fully recharged in order to
maintain the My Room Mode .
■ Using My Room Mode during DC charging
●When using My Room mode during DC charging , the amount of charge at the time of charge completion will be lower than when not using it . In addition , when DC charging during low outdoor temperatures and a high humidity environment , the windows may fog up . Turning on the cooling and
dehumidification functions
( �P . 433 ) will dehumidify the vehicle interior and remove fogging from the windows . In this case , the temperature control of the traction battery will be stopped and the amount of charge may decrease .
●When the battery is fully charged , the system will exit the My Room
Mode .
■ When “ My Room Mode ” is used while the traction battery is fully charged
When the power switch is turned on while the traction battery is fully charged and the charging connector that supplies power is connected , “ Charging Port Lid is Open ” is displayed on the multi-information display . In this case , press on the
meter control switches to display the setting screen of “ My Room Mode ”, and then select “ My Room Mode ”.
When “ My Room Mode ” is used while the traction battery is fully charged , the electric power of the traction battery may be consumed . In this case , charging may be performed again .