410 6-1 . Using the air conditioning system and defogger
WARNING
■ To prevent the windshield from fogging up
Do not use the windshield defogger switch during cool air operation in extremely humid weather . The difference between the temperature of the outside air and that of the windshield can cause the outer surface of the windshield to fog up , blocking your vision .
■ To prevent burns
●Do not touch the rear view mirror surfaces when the outside
rear view mirror defoggers are on .
●Do not touch the glass at lower part of the windshield or to the side of the front pillars when the windshield wiper de-icer is on .
NOTICE
■ To prevent 12-volt battery discharge
Do not leave the air conditioning system on longer than necessary
when the EV system is off .
■ When repairing / replacing parts of the air conditioning system
Have repair / replacement performed by your SUBARU dealer .
When a part of the air conditioning system , such as the evaporator , is to be replaced , it must be
replaced with a new one .
Using automatic mode
1 Press the automatic mode switch .
The dehumidification function begins to operate . Air outlets and
fan speed are automatically adjusted according to the temperature setting and humidity .
2 Adjust the temperature setting .
3 To stop the operation , press the “ OFF ” switch .
If the fan speed setting or air flow modes are operated , the automatic mode indicator goes off . However , automatic mode for functions other than that operated is maintained .
■ Using automatic mode
Fan speed is adjusted automatically according to the temperature setting and the ambient conditions .
Therefore , the fan may stop for a while until warm or cool air is ready
to flow immediately after the automatic mode switch is pressed .
Adjusting the temperature for driver and front passenger seats separately (“ SYNC ” mode )
To turn on the “ SYNC ” mode , perform any of the following procedures :
• Press the “ SYNC ” mode switch .
• Adjust the front passenger ’ s side temperature setting .
The indicator comes on when the “ SYNC ” mode is on .