5-3 . Operating the lights and wipers
253 detect the brightness of the surroundings . This may cause the low beams to remain on or the high beams to flash or dazzle pedestrians or vehicles ahead . In such a case , it is necessary to manually change between the high beams and low beams .
• When there are lights similar to
headlights or tail lights in the surrounding area
• When headlights or tail lights of
vehicles ahead are turned off , dirty , changing color , or not aimed properly
• When the headlights are repeatedly changing between the high beams and low beams .
• When use of the high beams is inappropriate or when the high beams may be flashing or dazzling pedestrians or other drivers .
• When the vehicle is used in an area in which vehicles travel on
the opposite side of the road of the country for which the vehicle was designed , for example using
a vehicle designed for right-hand traffic in a left-hand traffic area , or vice versa
• When it is necessary to disable the system : �P . 261
• Situations in which the sensors
may not operate properly : �P . 264
■ Temporarily reducing front camera sensitivity
The sensitivity of the front camera can be temporarily reduced .
1 Turn the power switch off with the following conditions met .
●The headlight switch is in or position .
●The headlight switch lever is in the low beam position .
●The Automatic High Beam switch is on .
2 Turn the power switch to ON .
3 Within 60 seconds after performing step 2 , push the headlight switch lever to the high beam position then pull it to the original position quickly 10 times , then leave the lever in its original position .
4 If the sensitivity is changed , the Automatic High Beam indicator will blink 3 times .
Turning the high beams on / off manually
■ Changing to the high beams
Push the lever forward .
The Automatic High Beam indicator will turn off and the high beam indicator will turn on .
Pull the lever to its original position to enable the Automatic High Beam system again .
■ Changing to the low beams
Press the Automatic High Beam switch .
The Automatic High Beam indicator will turn off .
Press the switch to enable the Automatic High Beam system again .
5
Driving