2-2 . Charging
131
When charging cannot be carried out
When charging does not start , even though the normal procedure is followed , check each of the following items . If a message is shown on the multi-information display , also refer to P . 138 .
When charging cannot be carried out
Refer to the following table and carry out the appropriate correction procedure .
■ The error warning indicator on the CCID ( Charging Circuit Interrupting Device ) flashes
Likely cause
Electrical leakage detection function or self-diagnostic function operates and power is cut off
Correction procedure
When the voltage is insufficient , the error warning indicator may flash when there is noise interference . Perform a reset and connect to a proper power source . ( �P . 88 )
If charging does not start , immediately stop charging and contact your SUBARU dealer .
2
Electric Vehicle system
■ Charging indicator of the charging port does not illuminate , even though charging connector is connected .
Likely cause
Plug is not properly connected to outlet
Power is out
Remote switch is off
Correction procedure
Check that the plug is properly connected to the outlet .
After power is restored , carry out the charging procedure again .
If the remote switch is equipped , turn the switch on .