|
& Switching Power Status s09ap02
1. Apply the parking brake.
2. Shift the select lever into the“ P” position.
3. Depress the brake pedal.
|
5. When the keyless access with pushbutton start system is deactivated, press the push-button ignition switch with the brake pedal released. The status of the push-button ignition switch then changes to“ ON”. |
||||
|
4. Hold the access key fob with the buttons facing you, and touch the push-button ignition switch with it. When the communication between the access key fob and the vehicle is completed, a chime( ding) will sound. At the same time, the status of the push-button ignition switch changes to either of the following.. When the keyless access with pushbutton start system is deactivated:“ ACC”
. Under other conditions:“ ON”
|
NOTE
If the power does not switch even though the above procedure was followed precisely, contact your SUBARU dealer.
& Starting Engine s09ap03
1. Apply the parking brake.
2. Shift the select lever into the“ P” position.
3. Depress the brake pedal.
|
4. Hold the access key fob with the buttons facing you, and touch the push-button ignition switch with it. When the communication between the access key fob and the vehicle is completed, a chime( ding) will sound. At the same time, the push-button ignition switch turns to the“ ACC” or“ ON” position.
5. After the push-button ignition switch turns to the“ ACC” or“ ON” position, while depressing the brake pedal, press the push-button ignition switch.
NOTE
If the engine does not start even though the above procedure was followed precisely, contact your SUBARU dealer.
|
In Case of Emergency
9
|