268
Light Control Switch
changed from the high beam to the low beam. – When your vehicle passes an oncoming vehicle suddenly in a blind curve.
– When another vehicle passes in front of your vehicle.
– When an oncoming vehicle or vehicle ahead comes in and out of view because of continuous curves, median strips, roadside trees, etc.
. If the stereo camera detects the light of the front fog lights of an oncoming vehicle, the headlight mode may change from the high beam to the low beam automatically.
. The headlight mode may change from the high beam to the low beam, or the low beam mode may continue, when affected by a street light, traffic signal, illumination of an advertisement board, or a reflective object such as a road sign and signboard.
. The timing of the change of headlight mode may differ due to the following factors. – Color or brightness of the headlights of an oncoming vehicle or the tail lights of a vehicle ahead.
– The headlights of the oncoming vehicle or the tail lights of the vehicle ahead are covered with mud, snow, etc. – Movement and direction of an oncoming vehicle or a vehicle ahead.
– When the headlights of an oncoming vehicle or the tail lights of a vehicle ahead illuminate on only one side.
– When the oncoming vehicle or vehicle ahead is a motorcycle. – Conditions of a road( slope, curve, road surface, etc.). – Number of passengers and weight of loaded cargo. – Limitation of the detection ability of the stereo camera.
& Daytime Running Light System s03ah04
WARNING
When the daytime running lights are illuminated, the tail lights do not illuminate. When it becomes dark outside, turn the light switch to the“” position to illuminate the headlights and tail lights. This will improve visibility and allow other drivers to see your vehicle more easily.
The daytime running lights will automatically illuminate when the following conditions are fulfilled.. The engine is running.. The parking brake is fully released.
. The light control switch is in the“ AUTO”,“” or“” position( except for Canada models).
. The light control switch is in the“ AUTO”,“” or“ OFF” position( for Canada models).
. The select lever is in a position other than the“ P” position.
NOTE
When the light switch is in the“” position, the instrument panel illumination, front side marker lights, tail lights and license plate lights are also illuminated.