Warning and Indicator Lights 191 |
||||||||||
|
damage and a fast leak that causes the tire to lose air rapidly. If you have a flat tire, refer to“ Flat Tires” FP488.
When a replacement tire is mounted or a wheel rim is replaced without the original pressure sensor / transmitter being transferred, the Low tire pressure warning light will illuminate steadily after blinking for approximately one minute. This indicates the TPMS is unable to monitor all four road wheels. Contact your SUBARU dealer as soon as possible for tire and sensor replacement and / or system resetting. If the light illuminates steadily after blinking for approximately one minute, promptly contact a SUBARU dealer to have the system inspected.
|
CAUTION
The tire pressure monitoring system is NOT a substitute for manually checking tire pressure. The tire pressure should be checked periodically( at least monthly) using a tire gauge. After any change to tire pressure( s), the tire pressure monitoring system will not re-check tire inflation pressures until the vehicle is first driven more than 20 mph( 32
|
km / h). After adjusting the tire pressures, increase the vehicle speed to at least 20 mph( 32 km / h) to start the TPMS re-checking of the tire inflation pressures. If the tire pressures are now above the severe low pressure threshold, the low tire pressure warning light should turn off a few minutes later. Therefore, be sure to install the specified size for the front and rear tires.
& ABS Warning Light
|
CAUTION
s03ae09
|
. If any of the following conditions occur, we recommend that you have the ABS repaired at the first available opportunity by your SUBARU dealer.
– The warning light does not illuminate when the ignition switch is turned to the“ ON” position.
– The warning light illuminates when the ignition switch is turned to the“ ON” position, but it does not turn off even after starting the vehicle.
|
– The warning light illuminates during driving.
. When the warning light is on( and brake system warning light is off), the ABS function shuts down; however, the conventional brake system continues to operate normally.
The ABS warning light illuminates together with the brake system warning light if the EBD system malfunctions. For further details of the EBD system malfunction warning, refer to“ Brake System Warning Light” FP192.
NOTE
If the warning light behavior is as described in the following conditions, the ABS may be considered normal.
. The warning light illuminates right after the engine is started but turns off immediately, remaining off.
. The warning light remains illuminated after the engine has been started, but it turns off while driving.
. The warning light illuminates during driving, but it turns off immediately and remains off.
– CONTINUED –
|
3
Instruments and Controls
|