162
Rear Gate( Outback / Subaru Outback Wilderness)
is opened. The rear gate will close automatically.
NOTE
. If the rear gate is moved slowly, it may not operate automatically open or close.
. When leaving the vehicle, make sure that all doors and the rear gate are completely locked.
! Memory function s02aj0101
The preferred rear gate height can be registered.
! Registration of the rear gate height s02aj010101
To register the rear gate height, perform the following procedures.
1. Open the rear gate and stop it at the preferable height.
1 Power rear gate button
2. Press and hold the power rear gate button to register the height. An electronic chirp sounds and the hazard warning flashes for confirmation.
The rear gate will stop at the registered position when the memory function is on.
NOTE
. Register the rear gate height to turn on the“ Power Rear Gate Memory” automatically. For details, refer to“ Car settings” FP232.
. To change the registered height, perform the registering procedure again.
. It is possible to register the height from approximately 2 in( 5 cm) or more from the completely closed position.
! Deactivation of the memory function s02aj010103
Deactivate the memory function to open the rear gate fully. Perform either of the following operation to deactivate the memory function.
– Deactivate the“ Power Rear Gate Memory” function on the center information display( CID). Refer to“ Car settings” FP232.
– Register the position of the rear gate at the fully open position.
! Utilizing the memorized rear gate height s02aj010102
To open the rear gate and stop it at the registered height, perform the following procedure.
1. Check that“ Power Rear Gate Memory” is on. Refer to“ Car settings” FP232.
2. Press and hold any of the power rear gate button.
NOTE
The rear gate will open to the position that is stored in the memory function even if the rear gate is opened by the reverse function.