|
& Switching Power Status s09ap02
1 . Apply the parking brake .
2 . Shift the select lever into the “ P ” position .
3 . Depress the brake pedal .
|
5 . When the keyless access with pushbutton start system is deactivated , press the push-button ignition switch with the brake pedal released . The status of the push-button ignition switch then changes to “ ON ”. |
||||
|
4 . Hold the access key fob with the buttons facing you , and touch the push-button ignition switch with it . When the communication between the access key fob and the vehicle is completed , a chime ( ding ) will sound . At the same time , the status of the push-button ignition switch changes to either of the following . . When the keyless access with pushbutton start system is deactivated : “ ACC ”
. Under other conditions : “ ON ”
|
NOTE
If the power does not switch even though the above procedure was followed precisely , contact your SUBARU dealer .
& Starting Engine s09ap03
1 . Apply the parking brake .
2 . Shift the select lever into the “ P ” position .
3 . Depress the brake pedal .
|
4 . Hold the access key fob with the buttons facing you , and touch the push-button ignition switch with it . When the communication between the access key fob and the vehicle is completed , a chime ( ding ) will sound . At the same time , the push-button ignition switch turns to the “ ACC ” or “ ON ” position .
5 . After the push-button ignition switch turns to the “ ACC ” or “ ON ” position , while depressing the brake pedal , press the push-button ignition switch .
NOTE
If the engine does not start even though the above procedure was followed precisely , contact your SUBARU dealer .
|
In Case of Emergency
9
|