282
Mirrors
! Reprogramming a Single HomeLink ® button s03ap100305
To program a previously trained button , follow these steps :
1 . Press and hold the desired HomeLink ® button . DO NOT release the button .
2 . The indicator light will begin to slowly flash orange after 20 seconds . The HomeLink ® button can be released at this point . Proceed with “ Programming a New HomeLink ® button ” - step 3 .
3 . If you do not complete the programming of a new device to the button , it will revert to the previously stored programming .
! Garage Door Two-Way Communication s03ap100306
HomeLink ® has the capability of communicating with your garage door opener . HomeLink ® can receive and display “ closing ” or “ opening ” status messages from compatible garage door opener systems . At any time , HomeLink ® can also recall and display the last recorded status communicated by the garage door opener to indicate your garage door being “ closed ” or “ opened ”.
HomeLink ® has the capability of receiving this communication from the garage door opener at a range up to 820 feet ( 250 m ).
Range may be reduced by obstacles such as houses or trees . You may have to slow your vehicle speed to successfully receive the garage door opener communication .
! Programming Two-Way Communication s03ap100307
1 Status Indicators
Within 5 seconds after programming a new HomeLink ® button , both of HomeLink ’ s garage door status indicators will flash rapidly green indicating that the garage door two-way communication has been enabled . If your garage door status indicators flashed , two-way communication programming is complete .
If the garage door status indicators do not flash , additional HomeLink ® information and programming videos can be found online at www . HomeLink . com and www . youtube . com / HomeLinkGentex .
! Using Two-Way Communication s03ap100308
1 Status Indicator
Recall and display ( at any time ) the last recorded garage door status message communicated to HomeLink ® by simultaneously pressing HomeLink ® buttons 1 and 2 for 2 seconds . HomeLink ® will display the last recorded status for 3 seconds .
If two-way communication programming is successful , HomeLink ® will display the status of your garage door opener with arrow indicators ( see below ).