|
. The push-button ignition switch is turned to the “ OFF ” status ( models with “ keyless access with push-button start system ”).
. The key is pulled out from the ignition switch ( models without “ keyless access with push-button start system ”).
|
display models ).
! Sensor for the auto on / off headlights s03ah0101
|
& High / Low Beam Change ( Dimmer ) |
s03ah02 |
|
The low beam headlights will turn off under any of the following conditions .
. 3 minutes have passed since the low beam headlights were illuminated by the welcome lighting function .
. 30 seconds have passed since the door is opened and closed .* 1
. The light control switch is turned to a position other than “ AUTO ”.
. The locking procedure is performed twice . When performing the unlocking procedure after performing the locking procedure , perform the locking procedure twice again .
* 1 : The setting for the period of time in which the low beam headlights remain on by the welcome lighting function can be changed by a SUBARU dealer . Contact your SUBARU dealer for details . Also , you can change the setting by operating the center information display . For details , refer to “ Car settings ” FP230 ( 11.6-inch display models ) or “ Car Settings icon ” FP250 ( dual 7.0-inch
|
The sensor is on the instrument panel as shown in the illustration .
CAUTION
If any object is placed on or near the sensor , the sensor may not detect the level of the ambient light correctly and the auto on / off headlights may not operate properly .
|
1 High beam 2 Low beam
While the light control switch is in the “ ” or “ ” position in a dark place , the headlights will turn on .
When the headlights are on high beam , the high beam indicator light “ ” on the combination meter is also on .
NOTE
While the light control switch is in the “ ” position and the lever is the high beam position , the high beam assist function will be on standby .
|
3
Instruments and Controls
|
||||||
– CONTINUED – |