Seatbelts 49
! Front seatbelts
1. Adjust the seat position:
s01ae0601
Driver’s seat: Adjust the seatback to the
upright position. Move the seat as far from
the steering wheel as practical while still
maintaining full vehicle control.
Front passenger’s seat: Adjust the seatback
to the upright position. Move the seat
as far back as possible.
2. Sit well back in the seat.
3. Pick up the tongue plate and pull the
belt out slowly. Do not let it get twisted.
. If the belt stops before reaching the
buckle, return the belt slightly and pull it
out more slowly.
. If the belt still cannot be unlocked, let
the belt retract slightly after giving it a
strong pull, then pull it out slowly again.
4. Insert the tongue plate into the buckle
until you hear a click.
5. To make the lap part tight, pull up on
the shoulder belt.
6. Place the lap belt as low as possible on
your hips, not on your waist.
! Adjusting the front seat shoulder
belt anchor height
s01ae060101
The shoulder belt anchor height should be
adjusted to the position best suited for the
driver/front passenger. Always adjust the
anchor height so that the shoulder belt
passes over the middle of the shoulder
without touching the neck.
To raise:
Push and hold the upper part of the anchor
and slide the anchor up.
To lower:
Push and hold the upper part of the anchor
and slide the anchor down.
Pull down the anchor to make sure that it is
locked in place.
– CONTINUED –
1
Seat, Seatbelt and SRS Airbags