460
Rear Gate (Outback) – If the Rear Gate Cannot Be Opened
4. Hold the access key fob with the
buttons facing you, and touch the pushbutton
ignition switch with it.
When the communication between the
access key fob and the vehicle is completed,
a chime (ding) will sound. At the
same time, the push-button ignition switch
turns to the “ACC” or “ON” position.
5. After the push-button ignition switch
turns to the “ACC” or “ON” position, while
depressing the brake pedal, press the
push-button ignition switch.
NOTE
If the engine does not start even though
the above procedure was followed
precisely, contact your SUBARU dealer.
9-10. Rear Gate (Outback) – If
the Rear Gate Cannot Be
Opened
s09au
In the event that you cannot open the rear
gate by pressing the rear gate opener
button (all models) or using the power rear
gate (if equipped), you can open it from
inside the cargo area.
CAUTION
Never operate the rear gate lock
release lever with your fingers because
doing so may cause an injury.
Always use a flat-head screwdriver
or a similar tool.
1. Remove the access cover at the
bottom-center of the rear gate trim using
flat-head screwdriver.
Models without power rear gate
1) Rear gate lock release lever