430
Trailer Hitch (Outback – If Equipped)
hitch receiver, the trailer could
get loose and create a traffic
safety hazard.
. Use only the ball mount supplied
with this hitch. Use the hitch only
as a weight carrying hitch. Do not
use with any type of weight distributing
hitch.
. The standard bumper beam must
be installed after you remove the
trailer hitch. Consult a SUBARU
dealer for purchase of a standard
bumper beam if you do not have
the original.
. If a trailer hitch is installed, it is
not possible to install the rear
towing hook.
The maximum gross trailer weight and
maximum gross tongue weight are indicated
in the following table.
2.4 L models
2.5 L models
Maximum
gross trailer
weight
3,500 lbs
(1,588 kg)
2,700 lbs
(1,224 kg)
Maximum
gross tongue
weight
350 lbs
(159 kg)
270 lbs
(122 kg)
When towing a trailer, refer to “Trailer
Towing (Outback)” ☞P432.
& Connecting a Trailer
s08ak01
1. Remove the receiver cover from the
hitch receiver tube. Then insert the ball
mount into the hitch receiver tube.
2. Insert the hitch pin into the hole located
on the hitch receiver tube so that the pin
passes through the ball mount.
3. Insert the safety pin through the provided
hole on the hitch pin securely.
4. Check the ball mount assembly by
pulling on it to make sure it does not come
off the hitch receiver.