Loading Your Vehicle 425
hazard.
. Do not install a roof tent on the
vehicle. Doing so may damage
the vehicle and create a safety
hazard. SUBARU warranties do
not cover vehicle damage resulting
from use of a roof tent.
Cargo can be carried after securing the
roof crossbar kit to the roof molding and
installing the appropriate carrying attachment.
When installing the roof crossbar kit,
follow the manufacturer’s instructions.
When carrying cargo on the roof using the
roof crossbar kit and carrying attachments,
never exceed the maximum load limit as
explained below. You should also be
careful that the vehicle does not exceed
the Gross Vehicle Weight Rating (GVWR)
and front and rear Gross Axle Weight
Rating (GAWR). For information about
loading cargo into or onto your vehicle,
refer to “Loading Your Vehicle” ☞P422.
The maximum total load on the roof
(including crossbars, carrying attachments
and cargo) must not exceed 88 lbs (40
kg). Refer to the crossbar installation
instructions for the maximum crossbar
capacity. Place the heaviest load at the
bottom, close to the roof, and evenly
distribute the cargo. Always properly secure
all cargo.
! Installing carrying attachments on
the crossbars
s08aj0601
When installing any carrying attachments
such as the load carriers, crossbars, bike
carrier, ski carrier, kayak carrier, cargo
basket, etc., follow the manufacturer’s
instructions for the load capacity and make
sure that the attachments are securely
installed. Use only attachments designed
specifically for the crossbars. Before operating
the vehicle, make sure that the cargo
is properly secured on the attachment.
NOTE
Remember that the vehicle’s center of
gravity is altered with the weight of the
load on the roof, thus affecting the
driving characteristics.
Drive carefully. Avoid rapid starts, hard
cornering and abrupt stops. Crosswind
effects will be increased.
! Removal and installation of the
crossbars
s08aj0602
Each of the two roof moldings has two
mounting points for crossbars. Each
mounting point is fitted with a cover. Use
a screwdriver to open the covers. When
installing the crossbars on the roof molding,
follow the manufacturer’s instructions.
– CONTINUED –
8
Driving Tips