258
Mirrors
cycle.
! To Operate the Compass Feature (if
equipped)
s03ap1002
1. To turn the compass feature on/off,
press and hold the “ ” switch for more
than 3 seconds or until the display turns
on/off. The compass feature will default to
on with each ignition cycle.
2. If the display reads “C”, slowly drive the
vehicle in circles until compass is calibrated.
Compass calibration zones
3. To adjust for compass zone variance:
(1) Find your current location and
zone number on the map.
(2) Press and hold the “ ” switch for
more than 6 seconds or until a zone
number appears in the display.
(3) Once the zone number appears in
the display, toggle the “ ” switch
again until your current location zone
number appears. After you stop pressing
the switch, your new zone number
will be saved. Within a few seconds,
the display will show a compass direction.
4. If the vehicle’s magnetics have changed
or if the compass appears inaccurate,
recalibrate the compass. Press and hold
the “ ” switch for more than 9 seconds or
until a “C” appears in the display. Once a
“C” appears in the display, slowly drive the
vehicle in circles until compass is calibrated.
! HomeLink ® Wireless Control System
s03ap1003
The HomeLink ® Wireless Control System
provides a convenient way to replace up to
three hand-held radio frequency remotes
used to activate devices such as gate
operators, garage door openers, entry
door locks, security systems, even home
lighting. The below steps are generic
programming instructions; for Genie and
Sommer garage door openers please go
directly to the HomeLink ® website. Additional
information and programming videos
can be found at www.HomeLink.
com and www.youtube.com/HomeLink-
Gentex.
CAUTION
. Before programming HomeLink ®
to a garage door opener or gate
operator, make sure that people
and objects are out of the way of
the device to prevent potential
harm or damage.
. When programming a garage
door opener, it is advised to park
outside of the garage.
. Do not use HomeLink ® with any
garage door opener that lacks
safety stop and reverse features
as required by U.S. federal safety
standards (this includes any garage
door opener model manufactured
before April 1, 1982). A
garage door that cannot detect
an object signaling the door to
stop and reverse does not meet
current U.S. federal safety standards.
. It is also recommended that a new
battery be placed in the handheld
remote (garage door opener
remote) of the device for quicker
and more accurate training.
. Turn the ignition switch to the
“ON” or “ACC” position before