Light Control Switch 245
CAUTION
If any object is placed on or near the
sensor, the sensor may not detect
the level of the ambient light correctly
and the auto on/off headlights
may not operate properly.
& High/Low Beam Change
(Dimmer)
1) High beam
2) Low beam
s03ah02
While the light control switch is in the “ ”,
“ ”, or “ ” position in a dark place, the
headlights will turn on.
When the headlights are on high beam, the
high beam indicator light “ ” on the
combination meter is also on.
NOTE
While the light control switch is in the
“ ” position and the lever is the high
beam position, the high beam assist
function will be on standby.
& Headlight Flasher
CAUTION
s03ah03
Do not hold the lever in the flashing
position for more than just a few
seconds.
To flash the headlights, pull the lever
toward you and then release it. The high
beam will stay on for as long as you hold
the lever. The headlight flasher works even
though the lighting switch is in the off
position.
When the headlights are on high beam, the
high beam indicator light “ ” on the
combination meter also illuminates.
& High Beam Assist Function
s03ah07
NOTE
. The high beam assist function utilizes
the stereo camera installed at the
position of the front map lights.
. For details on how to handle the
stereo camera, refer to the Owner’s
Manual supplement for the EyeSight
system.
The high beam assist function automatically
changes the headlight from high
beam to low beam (or vice versa).
When all of the following conditions are
met, the headlight will change to high
beam.
. When the vehicle speed increases to or
above 20 mph (32 km/h).
. There is no preceding or oncoming
vehicle.
. The forward area of the vehicle is dark.
. The road does not have a sharp curve.
When any of the following conditions are
– CONTINUED –
3
Instruments and Controls