134
Remote Keyless Entry System
give you an audible signal when the doors
lock and unlock.
Models with “keyless access with
push-button start system”:
If desired, you can turn the audible signal
off by operating the center information
display. For details, refer to “Car settings”
☞P215. Furthermore, the volume setting
of the audible signal can also be changed
by a SUBARU dealer. Consult your
SUBARU dealer for details.
Models without “keyless access with
push-button start system”:
Perform the following steps to deactivate
the audible signal. Take the same steps to
restore the function.
Steps Operation Time
1 Sit in the driver’s seat. —
2
Close all doors and the
rear gate.
—
Press and hold “ ” on
(1) the power locking
switch.
3
4
(2)
Insert the key into the
ignition switch and pull it
out at least 6 times.
Open and close the driver’s
door.
Within
10 sec.
Within
10 sec.
The hazard warning flashers flash 3 times
to indicate completion of the setting.
Your SUBARU dealer can perform the
above procedure for you.
& Selecting Hazard Warning
Flasher Operation
s02ae26
Using the hazard warning flasher, the
system will give you a visible signal when
the doors are locked or unlocked. If
desired, you can turn the hazard warning
flashers off by operating the center information
display. For details, refer to “Car
settings” ☞P215 (11.6-inch display models)
or “Vehicle setting icons” ☞P234 (dual
7.0-inch display models). The setting can
also be changed by a SUBARU dealer.
Consult your SUBARU dealer for details.
& Vehicle Finder Function
s02ae05
Use this function to find your vehicle
parked among many vehicles in a large
parking lot. Provided you are within 30 feet
(10 meters) of the vehicle, pressing the “ ”
button three times in a 5-second period will
cause your vehicle’s horn to sound once
and its hazard warning flashers to flash
three times.
NOTE
If the interval between presses is too
short when you press the “ ” button
three times, the system may not respond
to the signals from the remote
transmitter.
& Sounding a Panic Alarm
s02ae06
To activate the alarm, press the “PANIC”
button once.
The horn will sound and the hazard
warning flashers will flash.
To deactivate the panic alarm, press any
button on the remote transmitter. If a
button on the remote transmitter is not
pressed, the alarm will be deactivated after
approximately 30 seconds.
& Replacing the Battery
s02ae08
Refer to “Replacing Battery” ☞P516.