1-8
Seat, seatbelt and SRS airbags/Front seats
NOTE button on the access key fob.
. If the registered seat position cannot
be retrieved after performing the pre-
vious procedures, try the following
procedures.
(1) Press the “SET” button on the
driver’s door.
(2) Press the “ ” button on the
access key fob or touch the door
lock sensor to lock the doors.
(3) Perform the prior procedures
again.
. If the keyless access function is
disabled, the seat position cannot be
retrieved by gripping the driver’s door
handle. However, the seat position can
still be retrieved by pressing the “ ”
button on the access key fob. For
information about how to enable/dis-
able the keyless access function, refer
to “Disabling keyless access function”
F2-19.
. If a new position is registered for the
same access key fob, the previously
registered seat position is deleted. A chirp will sound, and the registered seat
position will be cleared.
! Clearing the registered seat posi-
tion with access key fob
S01AA020705
1. Close the driver’s door.
2. While holding the access key fob and
pressing the “SET” button, press the “ ”
head restraints are designed to
be installed into the rear seats
only. Do not attempt to install the
front seat head restraints into the
rear seats, or the rear seat head
restraints into the front seats.
& Head restraint adjustment
S01AA04
WARNING
. Never drive the vehicle with the
head restraints removed because
they are designed to reduce the
risk of serious neck injury in the
event that the vehicle is struck
from the rear. Also, never install
the head restraints the opposite
way around. Doing so will pre-
vent the head restraints from
functioning as intended. There-
fore, when you remove the head
restraints, you must reinstall all
head restraints correctly to pro-
tect vehicle occupants.
. All occupants, including the dri-
ver, should not operate a vehicle
or sit in a vehicle’s seat until the
head restraints are placed in their
proper positions in order to mini-
mize the risk of neck injury in the
event of a crash.
. The front seat head restraints are
designed to be installed into the
front seats only. The rear seat
Both the driver’s seat and front passen-
ger’s seat are equipped with head re-
straints. Both head restraints are adjusta-
ble in the following ways.
! Head restraint height adjustment
S01AA0401
1)
2)
Head restraint
Release button
To raise:
Pull the head restraint up.
To lower:
Push the head restraint down while press-