Subaru Outback Manuals 2018 Outback Owner's Manual | Page 321

Starting and operating/Parking your vehicle WARNING . Before exiting the vehicle, make sure that you turn off the engine. Otherwise, the parking brake may be released and an accident may occur. . If the brake system warning light turns on, the electronic parking brake system may be malfunc- tioning. Immediately stop your vehicle in a safe location, use tire stops under the tires to prevent the vehicle from moving and contact your SUBARU dealer. . If the electronic parking brake is operated under the following conditions, the electronic park- ing brake indicator light may flash. – the brake is overheated – the vehicle is on a steep slope In such cases, the vehicle may start to move which may lead to an accident. Always use the tire stops. CAUTION . When the electronic parking brake cannot be applied due to a malfunction, contact your SUBARU dealer immediately for an inspection. If you have to park your vehicle in such conditions, perform the following procedure. – Stop your vehicle in a flat location. – Shift the select lever in the “P” position. When the select le- ver cannot be shifted into the “P” position, you must release shift lock. Refer to “Shift lock function” F7-25. – Use tire stops under the tires to prevent the vehicle from moving. . Never drive with the parking brake applied in order to avoid unnecessary wear on the brake linings. Before starting to drive, always make sure that the park- ing brake has been released and that the electronic parking brake indicator light has turned off. . The braking power of the electro- nic parking brake may not be sufficient when strong braking 7-41 power is needed (e.g., when park- ing on a steep slope while towing a trailer (Outback)). Your vehicle is equipped with an electronic parking brake. You can apply/release the parking brake by operating the parking brake switch. To apply: Depress the brake pedal and pull up the parking brake switch. To release: Press the parking brake switch firmly while the ignition switch is in the “ON” position and the brake pedal is depressed. Electronic parking brake indicator light When the parking brake is applied while the ignition switch is in the “ON” position, the following indicator lights illuminate. – CONTINUED –