Subaru Outback Manuals 2018 Outback Owner's Manual | Page 160

3-4 Instruments and controls/Ignition switch (models without push-button start system) Ignition switch (models with- out push-button start system) S03AA WARNING . Never turn the ignition switch to “LOCK” while the vehicle is being driven or towed because that will lock the steering wheel, prevent- ing steering control. And when the engine is turned off, it takes a much greater effort than usual to steer. . Before leaving the vehicle, al- ways remove the key from the ignition switch for safety and never allow an unattended child to remain in the vehicle. Failure to follow this procedure could re- sult in injury to a child or others. Children could operate the power windows, the moonroof or other controls or even make the vehicle move. ignition switch from the “ON” posi- tion to the “ACC” or “LOCK” posi- tion, thereby stopping the engine. Also, if the key is attached to a keyholder or to a large bunch of other keys, centrifugal force may act on it as the vehicle moves, resulting in unwanted turning of the ignition switch. The ignition switch has four positions: LOCK, ACC, ON and START. battery to go dead. . If the ignition switch will not move from the “LOCK” position to the “ACC” position, turn the steering wheel slightly to the left and right as you turn the ignition switch. & LOCK S03AA01 The key can only be inserted or removed in this position. The ignition switch will lock the steering wheel when you remove the key. If turning the key is difficult, turn the steering wheel slightly to the right and left as you turn the key. NOTE CAUTION Do not attach a large key holder or key case to either key. If it banged against your knees or hands while you are driving, it could turn the . Keep the ignition switch in the “LOCK” position when the engine is not running. . Using electrical accessories for a long time with the ignition switch in the “ON” or “ACC” position can cause the The key can be turned from “ACC” to “LOCK” only when the key is pushed in while turning it (all models) and the select lever is in the “P” position.