Subaru Outback Manuals 2018 Outback EyeSight Driving Assist System Manual | Page 101

Troubleshooting
Troubleshooting
Troubleshooting
Adaptive Cruise Control cannot be set.
Did you remember to press the
( CRUISE) switch?
If you have not pressed the
( CRUISE) switch,
( Adaptive Cruise
Control) will not be shown.
Is EyeSight operation temporarily stopped?
When EyeSight is temporarily stopped,
is displayed on the combination
meter display.
Set Adaptive Cruise Control again after the cause for the temporary stop has been
corrected.
Is
displayed?
Adaptive Cruise Control cannot be set when
is not displayed. Set Adaptive
Cruise Control when
is displayed.
is not displayed.
Are the requirements for setting cruise control met? In any of the following cases, will not be displayed.
• The brake pedal is depressed while driving or the brake pedal is not strongly depressed while stopping.
• The vehicle speed is not between approximately 0 MPH( 0 km / h) and 90 MPH( 145 km / h)( for Adaptive Cruise Control is operating).
• The vehicle speed is not between approximately 20 MPH( 30 km / h) and 90 MPH( 145 km / h)( for Conventional Cruise Control is operating).
• The combination meter indicates a position other than D.
• The driver’ s seatbelt is unfastened.
• Any door is opened( except the rear gate / trunk).
• The electronic parking brake is applied.
• The vehicle is on a steep grade.
• The X-MODE is turned on.( The X-MODE indicator illuminates.)
• The steering wheel is turned significantly in either direction.
• The EyeSight system is stopped temporarily( Adaptive Cruise Control).
97