Subaru Outback Manuals 2017 Outback Owner's Manual | Page 95

1-62 Seat, seatbelt and SRS airbags/*SRS airbag (Supplemental Restraint System airbag) deploys independently of the driver’s and front passenger’s SRS frontal airbags in the steering wheel and instrument panel. An impact sensor, which senses impact force, is located in each of the following locations. . In the left and right front doors . In the left and right center pillars . In the left and right rear wheel houses . In the airbag control module . In the left and right front fenders (only SRS curtain airbags are designed to deploy when the front sub sensors sense a severe impact.) A rollover sensor is also located inside the airbag control module. If both of the following sensors together sense an impact force above a predetermined level in a side collision, the control module causes both the SRS side airbag and curtain airbag on the impacted side to inflate regardless of whether the rear wheel house impact sensor on the same side senses an impact. . the impact sensor that is located in the airbag control module . one of the center pillar impact sensors or front door impact sensors If both of the following sensors together sense an impact force above a predetermined level in a side collision, the control module causes only the SRS curtain airbag on the impacted side to inflate. . the impact sensor that is located in the airbag control module . one of the rear wheel house impact sensors Even if a frontal collision occurs, both right and left SRS curtain airbags will deploy when the front sensor and the control unit determine that the impact results from an offset frontal collision. T he SRS curtain airbags are designed to deploy under the following conditions. . The driver’s SRS frontal airbag deploys or the driver’s and passenger’s SRS frontal airbags deploy in a frontal collision. . The system determines that the collision is an offset frontal collision. . The vehicle is in an extremely inclined state such as during a rollover. The SRS curtain airbags are basically not designed to deploy in the following cases. . In a frontal collision when the SRS frontal airbags do not deploy or the system determines that the collision is other than an offset frontal collision . In most lesser inclined states If the rollover sensor detects rollover of the vehicle, the control module inflates the SRS curtain airbags. At this time, the driver’s and front passenger’s seatbelt pretensioners also operate at the same time. After the deployment, the SRS side airbag immediately starts to deflate. The time required from detection of an impact to deflation of an SRS side airbag after deployment is shorter than the blink of an eye. The SRS curtain airbag remains inflated for a while following deployment then slowly deflates. The SRS side airbag and SRS curtain airbag deploy even when no one occupies the seat on the side on which an impact is applied. The SRS side airbag and SRS curtain airbag are designed as follows: . to deploy in the event of an accident involving a moderate to severe side impact collision . to function on a one-time-only basis. The SRS side airbag and SRS curtain airbag are not designed to deploy in the following cases: . in most lesser side impacts