Subaru Outback Manuals 2017 Outback Owner's Manual | Page 507

11-4 Maintenance and service/Maintenance precautions guard against getting oil or fluids in your eyes. If something does get in your eyes, thoroughly wash them out with clean water. . Do not tamper with the wiring of the SRS airbag system or seatbelt pretensioner system, or attempt to take its connectors apart, as that may activate the system or it can render it inoperative. NEVER use a circuit tester for these wiring. If your SRS airbag or seatbelt pretensioner needs service, consult your nearest SUBARU dealer. NOTE SUBARU does not endorse the use of non-SUBARU approved flushing systems and strongly advises against performing these services on a SUBARU vehicle. Non-SUBARU approved flushing systems use chemicals and/or solvents which have not been tested or approved by SUBARU. SUBARU warranties do not cover any part of the vehicle which is damaged by adding or applying chemicals and/or solvents other than those approved or recommended by SUBARU. & Before checking or servicing in the engine compartment WARNING . Always stop the engine and apply the parking brake to prevent the vehicle from moving. . Always let the engine cool down. Engine parts become very hot when the engine is running and remain hot for some time after the engine is stopped. . Do not spill engine oil, engine coolant, brake fluid or any other fluid on hot engine components. This may cause a fire. . When the ignition switch is in the “ON” position, the cooling fan may operate suddenly even when the engine is stopped. If your body or clothes come into contact with a rotating fan, that could result in serious injury. To avoid risk of injury, perform the following precautions. – Models with push-button start system: Always turn the push-button ignition switch to the “OFF” position and confirm that the operation indicator on the switch is turned off. Then take the access key out from the vehicle. – Models without push-button start system: Always remove the key from the ignition switch. . Before performing any servicing on a vehicle equipped with a remote engine start system temporarily place that system in the service mode to prevent it from unexpectedly starting the engine.