Subaru Outback Manuals 2017 Outback Owner's Manual | Page 408

Starting and operating/Vehicle Dynamics Control system snow tires or winter tires . Activation of the Vehicle Dynamics Control system will cause operation of the steering wheel to feel slightly different compared to that for normal conditions. . It is always important to reduce speed when approaching a corner, even if the vehicle is equipped with Vehicle Dynamics Control. . Always turn off the engine before replacing a tire as failure to do so may render the Vehicle Dynamics Control system unable to operate correctly. & Vehicle Dynamics Control system monitor Refer to “Vehicle Dynamics Control warning light/Vehicle Dynamics Control operation indicator light” F3-24 and “Vehicle Dynamics Control OFF indicator light” F325. & Vehicle Dynamics Control OFF switch 7-37 operation, the Vehicle Dynamics Control OFF indicator light on the combination meter illuminates. The Vehicle Dynamics Control system will be deactivated. When the switch is pressed again to reactivate the Vehicle Dynamics Control system, the Vehicle Dynamics Control OFF indicator light turns off. You should not deactivate the Vehicle Dynamics Control system except under the above-mentioned situations. CAUTION Pressing the Vehicle Dynamics Control OFF switch deactivates the Vehicle Dynamics Control system. Creating an adequate driving wheel slip by deactivating the Vehicle Dynamics Control system temporarily may help to escape from the following situations. Use the Vehicle Dynamics Control OFF switch as necessary. . a standing start on a steeply sloping road with a snowy, gravel-covered, or otherwise slippery surface . extrication of the vehicle when its wheels are stuck in mud or deep snow When the switch is pressed during engine The Vehicle Dynamics Control system helps prevent unstable vehicle motion such as skidding using control of the brakes and engine power. Do not turn off the Vehicle Dynamics Control system unless it is absolutely necessary. If you must turn off the Vehicle Dynamics Control system, drive very carefully based on the road surface condition. NOTE . When the switch has been pressed to deactivate the Vehicle Dynamics Control system, the Vehicle Dynamics Control system automatically reactivates itself the next time the ignition switch is turned to the “LOCK”/“OFF” – CONTINUED –