7-28
Starting and operating/Continuously variable transmission
NOTE
The transmission may downshift, depending on the way the accelerator
pedal is depressed to accelerate the
vehicle again.
& Shift lock function
The shift lock function helps prevent the
improper operation of the select lever.
. The select lever cannot be operated
unless the ignition switch is turned to the
“ON” position and the brake pedal is
depressed.
. The select lever cannot be moved from
the “P” position to any other position
before the brake pedal is depressed.
Depress the brake pedal first, and then
operate the select lever.
. Only the “P” position allows you to turn
the key from the “ACC” position to the
“LOCK” position and remove the key from
the ignition key cylinder (models without
“keyless access with push-button start
system”).
. Only the “P” position allows you to turn
the push-button ignition switch to the
“OFF” position (models with “keyless
access with push-button start system”).
. If the ignition switch is turned to the
“LOCK”/“OFF” position while the select
lever is in the “N” position, the select lever
may not be moved to the “P” position after
a period of time. Therefore, move the
select lever to the “P” position with the
brake pedal depressed soon after the
ignition switch is turned to the “LOCK”/
“OFF” position.
SUBARU dealer for an inspection as soon
as possible.
! Shift lock release
If the select lever cannot be operated, turn
the ignition switch back to the “ON”
position then move the select lever to th e
“P” position with the select lever button
pressed and brake pedal depressed.
! Shift lock release using the shift
lock release portion
Perform the following procedure to release
the shift lock.
1. Apply the parking brake and stop the
engine.
If the select lever does not move after
performing the above procedure, perform
the following steps.
. When the select lever cannot be
shifted from “P” to “N”:
Refer to “Shift lock release using the shift
lock release portion” F7-28.
. When the select lever cannot be
shifted from “N” to “R”, “P”:
Within 60 seconds after placing the ignition switch in the “ACC” position, move the
select lever to the “P” position with the
select lever button pressed and brake
pedal depressed.
If you must perform the above procedure,
the shift lock system (or the vehicle control
system) may be malfunctioning. Contact a
If the select lever does not move after
performing the above procedure, refer to
“Shift lock release using the shift lock
release portion” F7-28.
2. Open the lid of the pocket.