7-22
Starting and operating/Remote engine start system (dealer option)
(battery “+” should be pointed away from
the transmitter circuit board on the battery).
4. Carefully snap the case halves back
together, reinstall the phillips screw and
test the remote engine start system.
NOTE
1. Remove the small phillips screw located on the back side of the transmitter.
2. Carefully pry the remote engine start
transmitter halves apart using a small flathead screwdriver.
3. Remove the circuit board from the
bottom half of the case and remove the
battery and replace with a new one. Be
sure to observe the (+) sign on the old
battery before removing it to ensure that
the new battery is inserted properly
. This device complies with Part 15 of
the FCC Rules and with RSS-210 of
Industry Canada. Operation is subject
to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment and void warranty.
. To comply with the FCC RF exposure compliance requirements, no
change to the antenna or the device is
permitted. Any change to the antenna
or the device could result in the device
exceeding the RF exposure requirements and void user’s authority to
operate the device.