Instruments and controls/Mirrors
rolling-code-protected garage door openers in the U.S.A.” F3-67.
! Programming rolling-code-protected garage door openers in
the U.S.A.
If your garage door opener has a rolling
code feature, program the HomeLink®
Wireless Control System for it by following
steps 1 through 5 in “Garage door opener
programming in the U.S.A.” F3-66. Then
continue with the following steps.
The exact location and color of the button
may vary by brand of garage door opener.
If it is difficult to locate the training button,
refer to your garage door opener’s instruction manual.
3-67
NOTE
Some garage door openers may require you to do the above press-holdrelease sequence a third time to complete the programming.
4. The garage door opener should now
recognize the HomeLink® Wireless Control
System and your garage door opener
should activate when the HomeLink®
button is pressed.
! Programming for entrance gates
and garage door openers in
Canada
NOTE
The assistance of a second person
may make the programming quicker
and easier.
1. Unplug the motor of the entrance gate
or garage door opener from the outlet.
1)
Training button
2. Press the training button on the
garage door opener motor head unit
(which activates the “training light” on the
unit). Proceed to step 3 within 30 seconds.
3. Inside the vehicle, firmly press, hold for
2 seconds and release the HomeLink®
button that was programmed in the previous section. Press and release the
button a second time to complete the
programming procedure.
NOTE
If any of the HomeLink® buttons are
already programmed for other devices,
skip step 2 because it clears the
memory of all three buttons.
1. Locate the training button on the
garage door opener motor head unit.
– CONTINUED –