Instruments and controls/Light control switch
Malfunction of the high beam assist
function:
High beam assist warning indicator (yellow)
When the high beam assist function
malfunctions, the high beam assist warning indicator on the combination meter will
appear. In this case, have your vehicle
inspected by your SUBARU dealer.
Temporary stop of high beam assist
function:
If the high beam assist function stops
temporarily due to poor visibility or abnormal temperature, the message appears
on the combination meter. When the
condition is canceled, the system will be
restored.
3-51
NOTE
Even when the operation conditions of
the high beam assist function are met,
there may be a case in which the high
beam assist indicator does not illuminate and an abnormal condition warning is given. In this case, turn the
ignition switch to the “LOCK”/“OFF”
position and then the “ON” position
again. Check if the high beam assist
indicator illuminates. If the indicator
does not illuminate, have the vehicle
inspected at a SUBARU dealer.
! How to temporarily lower the
sensitivity of the high beam
assist function
The sensitivity of the high beam assist
function can be lowered by using the
following operations.
1. Turn the ignition switch to the “ON”
position.
1)
Automatic dimming on/off button
2. Press and hold the automatic dimming
on/off button for 15 to 20 seconds.
When the sensitivity of the high beam
assist function is lowered, the