Instruments and controls/Light control switch
! Sensor for the auto on/off headlights
& High/low beam change
(dimmer)
The sensor is on the instrument panel as
shown in the illustration.
To change from low beam to high beam,
push the turn signal lever forward. When
the headlights are on high beam, the high
beam indicator light “ ” on the combination meter is also on.
To switch back to low beam, pull the lever
back to the center position.
CAUTION
If any object is placed on or near the
sensor, the sensor may not detect
the level of the ambient light correctly and the auto on/off headlights
may not operate properly.
3-49
. Observe the following points in
order to operate the high beam assist
function properly.
– Do not touch the camera or the
lens.
– Do not apply any strong impact
to the camera or the inside mirror.
– Do not disassemble the camera
or inside mirror.
– Do not spill liquid on the inside
mirror and camera.
– Do not place any objects over the
dashboard.
– Do not carry excessive luggage.
– Do not modify the vehicle.
– When replacing the windshield
glass, use the genuine SUBARU
parts (or equivalent products).
! High beam assist function (if
equipped)
NOTE
. Do not overestimate the capacity of
the high beam assist function. The
driver always has the responsibility to
understand the surrounding situation,
to drive safely, and to change the
headlight mode manually if necessary.
– CONTINUED –