Instruments and controls/Multi information display
! BSD/RCTA (if equipped)
After entering the “BSD/RCTA” menu,
select the “Warning Volume” menu. You
can set the volume of the warning buzzer
for RCTA (Rear Cross Traffic Alert). You
can select “Max”, “Mid” or “Min”.
! RAB (if equipped)
After entering the “RAB” menu, select one
of the following menus.
NOTE
For models with RAB (Reverse Automatic Braking) system, refer to “Reverse Automatic Braking System” F763.
! Warning Volume
The volume of the warning buzzer that
sounds when the RAB (Reverse Automatic Braking) system is in operation can
be set in 3 stages (“Max”, “Mid” and “Min”).
! Sonar Audible Alarm
When the RAB (Reverse Automatic Braking) system is in operation, the buzzer that
sounds if an obstacle is detected in the
rear or if detection is not possible can be
activated or deactivated. Select “On” to
activate the buzzer. Select “Off” to deactivate the buzzer.
! Vehicle Setting
After entering the “Vehicle Setting” menu,
select one of the following menus.
! Keyless Entry System
After entering the “Keyless Entry System”
menu, select one of the following menus.
. Audible Signal (models with “keyless access with push-button start
system”):
The audible signal can be activated or
deactivated. Select “On” to activate. Select “Off” to deactivate.
. Hazard Warning Flasher (all models):
The hazard warning flasher operation can
be activated or deactivated. Select “On” to
activate. Select “Off” to deactivate.
. Driver Door Unlock (models with
“keyless access with push-button start
system”):
The door unlock selection function is
available for the “keyless access” entry
function. For details, refer to “Door unlock
selection function” F2-18. On this setting
menu, the door unlock selection function
for the driver’s door can be customized.
Select “Driver Door Only” to set as
“Operational”. Select “All” to set as “Nonoperational”.
3-45
. Rear Gate Unlock (Outback with
“keyless access with push-button start
system”):
The door unlock selection function is
available for the “keyless access” entry
function. For details, refer to “Door unlock
selection function” F2-18. On this setting
menu, the door unlock selection function
for the rear gate can be customized.
Select “Rear Gate Only” to set as “Operational”. Select “All” to set as “Non-operational”.
! Defogger
The defogger and deicer system can be
set for the continuous operation mode or
automatic shut-off mode. Select “Continuous” to select the continuous operation
mode. Select “15 minutes” to select the
automatic shut-off mode.
! Interior Light
The setting for the period of time in which
the interior lights remain on (OFF delay
timer) after closing the doors and/or the
rear gate can be set or customized. Select
the preferred seconds to customize the
operation period. Select “Off” to deactivate
the OFF delay timer.
– CONTINUED –