Subaru Outback Manuals 2017 Outback Owner's Manual | Page 174

Instruments and controls/Warning and indicator lights checking tire pressure. The tire pressure should be checked periodically (at least monthly) using a tire gauge. After any change to tire pressure(s), the tire pressure monitoring system will not re-check tire inflation pressures until the vehicle is first driven more than 20 mph (32 km/h). After adjusting the tire pressures, increase the vehicle speed to at least 20 mph (32 km/h) to start the TPMS re-checking of the tire inflation pressures. If the tire pressures are now above the severe low pressure threshold, the low tire pressure warning light should turn off a few minutes later. Therefore, be sure to install the specified size for the front and rear tires. & ABS warning light CAUTION . If any of the following conditions occur, we recommend that you have the ABS repaired at the first available opportunity by your SUBARU dealer. – The warning light does not illuminate when the ignition 3-19 switch is turned to the “ON” position. – The warning light illuminates when the ignition switch is turned to the “ON” position, but it does not turn off even after starting the vehicle. – The warning light illuminates during driving. . When the warning light is on (and brake system warning light is off), the ABS function shuts down; however, the conventional brake system continues to operate normally. but it turns off while driving. . The warning light illuminates during driving, but it turns off immediately and remains off. When driving with an insuffici