Instruments and controls/Light control switch
When exiting:
While the welcome lighting function is
activated, the low beam headlights will
remain illuminated even when either of the
following operation is done.
. The push-button ignition switch is
turned to the “OFF” status (models with
“keyless access with push-button start
system”)
. The key is pulled out from the ignition
switch (models without “keyless access
with push-button start system”)
The low beam headlights will turn off
under any of the following conditions.
. 3 minutes have passed since the low
beam headlights were illuminated by the
welcome lighting function.
. 30 seconds have passed since the
door is opened and closed. *1
. The light control switch is turned to a
position other than “AUTO”.
. The locking procedure is performed
twice. When performing the unlocking
procedure after performing the locking
procedure, perform the locking procedure
twice again.
for details. Also, you can change the setting by
operating the multi information display. For
details, refer to “Welcome Lighting” F3 42 .
For models with the genuine SUBARU naviga
tion system, you can change the setting by
using the navigation system. For details, refer to
the Owner’s Manual supplement for the naviga
tion system.
3-45
! Sensor for the auto on/off head-
lights
The sensor is on the instrument panel as
shown in the illustration.
CAUTION
If any object is placed on or near the
sensor, the sensor may not detect
the level of the ambient light cor-
rectly and the auto on/off headlights
may not operate properly.
*1: The setting for the period of time in which
the low beam headlights remain on by the
welcome lighting function can be changed by a
SUBARU dealer. Contact your SUBARU dealer
CONTINUED