Subaru Outback Manuals 2016 Outback EyeSight® Driving Assist System | Page 73

Lane Departure Warning
CAUTION In the following situations, the Lane Departure Warning will or may not activate: � Vehicle speed is approximately 30 MPH( 50 km / h) or less. � When the steering wheel is turned significantly to either side � When the vehicle is driving around a curve whose radius is 0.18 miles( 300 m) or smaller. � When the brake pedal is depressed or immediately after it is depressed � When the accelerator pedal is almost fully depressed and the vehicle is accelerating or immediately after accelerating � When the following distance behind a vehicle in front is short � While the turn signal is operating and for approximately 4 seconds after the turn signal lever has returned to its original position � For approximately 4 seconds after the hazard lamp has switched off � When the vehicle has not returned to the inside of the lane after the Lane
Departure Warning has activated � The lane is narrow. � When it is difficult for the camera to detect lane markings- There are no lane markings or they are very worn.- The lane markings are yellow.- It is difficult to detect lane markings as they are similar in color to the road surface.- The lane markings are narrow.
NOTE
� The following situations may cause incorrect lane detection and a faulty Lane Departure Warning to occur.- Tire tracks on a wet road or snow-covered road- Boundaries between snow and asphalt, marks from road repair, etc.- Shadows of guardrails- Lane markings are drawn in double- There are some lane markings left from roadwork or markings from the previous road.
� When the Lane Departure Warning OFF indicator light is illuminated, the Lane Departure Warning is inactive.
� Refer to page 70.
69