Subaru Outback Manuals 2015 Outback Owner's Manual | Page 380

Starting and operating/Remote engine start system (dealer option) . The select lever is in the “P” position. . All doors including the rear gate are closed. . The engine hood is closed. . The push-button ignition switch is in the “OFF” position. ! When starting the engine To start the engine with remote engine start system, briefly press the lock button twice within 2 seconds, then press and hold the lock button for 3 seconds. 1. Press the lock button briefly. The hazard warning flashers then flash once and the keyless buzzer chirps once. 2. Within 2 seconds, press the lock button briefly again. The hazard warning flashers then flash once again, and the keyless buzzer chirps once again. 3. After step 2, immediately press and hold the lock button. The hazard warning flashers then flash three times, and the horn will honk once. 4. Approximately 3 seconds after step 3, release the lock button. The engine will then start successfully. ! When stopping the engine Press and hold the lock button to stop the engine with remote engine start system. ! Automatic engine shutdown The remote engine start system will automatically shut down or will not start the engine under the following conditions. . The total run-time has exceeded 20 minutes. . Any door or the rear gate is opened. . The select lever is moved to any position other than “P”. . The engine hood is opened. . The push-button ignition switch is pressed. . The brake pedal is depressed. . The engine speed is 3,000 rpm or more. The time until the engine automatically stops differs according to the setting. To change the time until the engine automatically stops, contact your SUBARU dealer. However, local laws and regulations may prohibit changing this time. 7-15 & Models without “keyless ac- cess with push-button start system” Remote engine starter transceiver (fob) 1) Fob button ! Starting the engine NOTE All vehicle doors (including rear gate/ trunk lid) and the engine hood must be closed prior to activating the remote engine start system. Any open entry point will prevent starting or cause the engine to stop. The remote engine start system is acti- vated by pressing the fob button on your remote engine starter transceiver (fob) twice within 3 seconds. If the fob is within CONTINUED