3-58
Instruments and controls/Mirrors
recognize the HomeLink ® Wireless Control
System and your garage door opener
should activate when the HomeLink ®
button is pressed.
! Programming for entrance gates
and garage door openers in
Canada
1. Unplug the motor of the entrance gate
or garage door opener from the outlet.
NOTE
1. Locate the training button on the
garage door opener motor head unit.
The exact location and color of the button
may vary by brand of garage door opener.
If it is difficult to locate the training button,
refer to your garage door opener’s instruc-
tion manual.
1)
Training button
2. Press the training button on the
garage door opener motor head unit
(which activates the “training light” on the
unit). Proceed to step 3 within 30 seconds.
3. Inside the vehicle, firmly press, hold for
2 seconds and release the HomeLink ®
button that was programmed in the pre-
vious section. Press and release the
button a second time to complete the
programming procedure.
If any of the HomeLink ® buttons are
already programmed for other devices,
skip step 2 because it clears the
memory of all three buttons.
NOTE
Some garage door openers may re-
quire you to do the above press-hold-
release sequence a third time to com-
plete the programming.
4. The garage door opener should now
1)
2)
3)
HomeLink ® button 1
HomeLink ® button 2
HomeLink ® button 3