Subaru Outback Manuals 2015 Outback Owner's Manual | Page 130

Keys and doors/Alarm system than 2 seconds). All doors (and the rear gate (Outback)) will lock, an electronic chirp will sound once, the hazard warning flashers will flash once, and the security indicator light will start flashing rapidly. After rapid flashing for 30 seconds (stand- by time), the security indicator light will then flash slowly (twice approximately every 2 seconds), indicating that the system has been armed for surveillance. If any of the doors (rear gate or trunk lid) is not fully closed, an electronic chirp sounds five times, the hazard warning flashers flash five times to alert you that the doors (or the rear gate/trunk lid) are not properly closed. When you close the door, the system will automatically arm and doors will automatically lock. ! To arm the system using power door locking switch 1. Close all windows and the moonroof (if equipped). 2. Remove the key from the ignition switch (models without keyless access function)/make sure the push-button igni- tion switch is turned off (models with keyless access function). 3. Open the doors and get out of the vehicle. 4. Make sure that the engine hood (and the trunk lid (Legacy)) are locked. 5. Close the doors (and the rear gate (Outback)) but leave only the driver’s door or the front passenger’s door open. 6. Press the front side (“LOCK” side) of the power door locking switch to set the door locks. 7. Close the door. An electronic chirp will sound once, the hazard warning flashers will flash once and the security indicator light will start flashing rapidly. After rapid flashing for 30 seconds (standby time), the security indicator light will then flash slowly (twice approximately every 2 sec- onds), indicating that the system has been armed for surveillance. 2-29 ! To arm the system using the key- less access function (if equipped) 1. Close all windows and the moonroof (if equipped) 2. Turn the push-button ignition switch to the “OFF” position. 3. Open the doors and get out of the vehicle. 4. Make sure that the engine hood is locked. 5. Close all doors and the rear gate/trunk lid. 1) Door lock sensor CONTINUED