7-18
Starting and operating/Remote engine start system (dealer option)
4. For models without “keyless access
with push-button start system”, insert the
key into the ignition switch and turn to the
“START” position to restart the engine. For
models with “keyless access with pushbutton start system”, press the pushbutton ignition switch while depressing
the brake pedal to restart the engine.
Models without automatic climate control system:
Before exiting the vehicle, set the temperature controls to the desired setting
and operation. After the system starts the
engine, the heater or air conditioning will
activate and heat or cool the interior to
your setting.
& Entering the vehicle following remote engine start shutdown
& Service mode (models without “keyless access with
push-button start system”)
An alarm trigger may occur if the vehicle is
opened by the remote keyless entry
system/keyless access function within a
few seconds immediately following remote
engine start shutdown.
In service mode, the remote engine start
function is temporarily disabled to prevent
the system from unexpectedly starting the
engine while being serviced.
& Pre-heating or pre-cooling
the interior of the vehicle
Models with automatic climate control
system:
After the system starts the engine, the
automatic climate control system will
activate the “FULL AUTO” mode and heat
or cool the interior to the predetermined
median (room) temperature. No presetting of controls is necessary.
To engage or disengage service mode:
1. Enter the vehicle and close all vehicle
doors and the rear gate.
2. Verify that the select lever is in the “P”
position (AT and CVT models)
3. Depress and hold the brake pedal
4. Turn the ignition switch to the “ON”
position
5. Press and release the remote engine
start transmitter “ ” button three times.
The system will honk the vehicle’s horn
each time the button is pressed.
6. The system will pause for 1 second
then honk the vehicle’s horn three times to
indicate that the service mode has been
engaged or honk one time to indicate that
the service mode has been disengaged.
NOTE
When taking your vehicle in for service,
it is recommended that you inform the
service personnel that your vehicle is
equipped with a remote engine start
system.
& Remote transmitter program
(models without “keyless access with push-button start
system”)
New transmitters can be programmed to
the remote engine start system in the
event that a transmitter is lost, stolen,
damaged or additional transmitters are
desired (the system will accept up to eight
transmitters). New remote engine start
transmitters can be programmed according to the following procedure.
1. Open the driver’s door (the driver’s
door must remain opened throughout the
entire process).
2. Depress and hold the brake pedal.
3. Turn the ignition switch to “ON” then
“LOCK”, back to “ON” then “LOCK”, back
to “ON” then “LOCK”, then back to “ON” a
fourth time and leave the ignition “ON”