Instruments and controls/Turn signal lever
& Headlight flasher
& Daytime running light system
3-43
Turn signal lever
WARNING
The brightness of the illumination of
the high beam headlights is reduced
by the daytime running light system.
The light switch must always be
turned to the “ ” position when it
is dark outside.
CAUTION
Do not hold the lever in the flashing
position for more than just a few
seconds.
To flash the headlights, pull the lever
toward you and then release it. The high
beam will stay on for as long as you hold
the lever. The headlight flasher works
even though the lighting switch is in the
off position.
When the headlights are on high beam,
the high beam indicator light “ ” on the
combination meter also illuminates.
The high beam headlights will automatically illuminate at reduced brightness
when the engine has started, under the
following conditions.
. The parking brake is fully released.
”
. The light switch is in the off or “
position.
. The light switch is in the “AUTO”
position and the headlights do not turn
on automatically.
. The select lever is in a position other
than the “P” position (AT and CVT models).
NOTE
When the light switch is in the “
”
position, the front side marker lights,
tail lights and license plate lights are
illuminated.
To activate the right turn signal, push the
turn signal lever up. To activate the left
turn signal, push the turn signal lever
down. When the turn is finished, the lever
will return automatically. If the lever does
not return after cornering, return the lever
to the neutral position by hand.
To signal a lane change, push the turn
signal lever up or down slightly and hold it
during the lan H