Subaru Outback Manuals 2014 Outback Owner's Manual | Page 308

3-20 Instruments and controls/Warning and indicator lights CAUTION The tire pressure monitoring system is NOT a substitute for manually checking tire pressure. The tire pressure should be checked periodically (at least monthly) using a tire gauge. After any change to tire pressure(s), the tire pressure monitoring system will not re-check tire inflation pressures until the vehicle is first driven more than 20 mph (32 km/h). After adjusting the tire pressures, increase the vehicle speed to at least 20 mph (32 km/h) to start the TPMS re-checking of the tire inflation pressures. If the tire pressures are now above the severe low pressure threshold, the low tire pressure warning light should turn off a few minutes later. Therefore, be sure to install the specified size for the front and rear tires. & ABS warning light CAUTION . If any of the following conditions occur, we recommend that you have the ABS repaired at the first available opportunity by your SUBARU dealer. – The warning light does not illuminate when the ignition switch is turned to the “ON” position. – The warning light illuminates when the ignition switch is turned to the “ON” position, but it does not turn off even when the vehicle speed exceeds approximately 12 km/h (8 mph). – The warning light illuminates during driving. – The warning light flashes. . When the warning light is on (and brake system warning light is off), the ABS function shuts down; however, the conventional brake system continues to operate normally. . When the warning light is flashing, the ABS may be malfunctioning. However, the conventional brake system continues to operate normally. The ABS warning light illuminates together with the brake system warning light if the EBD system malfunctions. For further details of the EBD system mal- function warning, refer to “Brake system warning light” F3-21. NOTE If the warning light behavior is as described in the following conditions, the ABS may be considered normal. . The warning light illuminates right after the engine is started but turns off immediately, remaining off. . The warning light remains illuminated after the engine has been started, but it turns off when the vehicle speed reaches approximately 8 mph (12 km/h). . The warning light illuminates during driving, but it turns off immediately and remains off. When driving with an insufficient battery voltage such as when the engine is jump started, the ABS warning light may illuminate. This is due to the low battery voltage and does not indicate a malfunction. When the battery becomes fully charged, the light will turn off.