Keys and doors/Alarm system
will flash once, and the security indicator
light will start flashing rapidly. After rapid
flashing for 30 seconds (standby time), the
security indicator light will then flash
slowly (twice approximately every 2 seconds), indicating that the system has been
armed for surveillance.
light will turn off.
activation.
To unlock all other doors and the rear gate
(Outback), briefly press the disarm button
a second time within 5 seconds.
To enter the valet mode, change the
setting of your vehicle’s alarm system for
deactivation mode. Refer to “Activating
and deactivating the alarm system” F225. The security indicator light will continue to flash once every 3 seconds
indicating that the system is in the valet
mode.
If any of the doors or the rear gate is not
fully closed, an electronic chirp sounds
five times, the hazard warning flashers
flash five times to alert you that the doors
(or the rear gate) are not properly closed.
When you close the door, the system will
automatically arm and doors will automatically lock.
! Emergency disarming
If you cannot disarm the system using the
transmitter (i.e. the transmitter is lost,
broken or the transmitter battery is too
weak), you can disarm the system without
using the transmitter.
The system can be disarmed if you turn
the ignition switch from the “LOCK”/“OFF”
to the “ON” position with a registered key/
access key.
& Disarming the system
NOTE
Perform either of the following procedures.
. Briefly press the disarm button (for less
than 2 seconds) on the access key/remote
transmitter.
. Carry the access key and perform
either of the following procedures (models
with “keyless access with push-button
start system”).
– Grip the front door handle.
– Press the rear gate opene ȁ